Sale

MR. JO Bondkot – STD

MR. JO Bondkot – CLR
MR. JO Tecseal – CRP

₹906.00 – ₹16,552.00 Inclusive of all taxes

Two component 50 PHR solvent free standard epoxy bonding agent.

SKU: ADH/STD
Clear

Description

MR. JO Bondkot – STD is a two-part epoxy system with medium viscosity. It is solvent-free and easy to apply. You can use it for concrete bonding and structural rehabilitation. Moreover, it offers strong resistance to saltwater. So, it is a great choice for tough and lasting repairs.

  • Color: Pale yellow
  • Pot life @25°C: 40-65 mins
  • Mixing Ratio: 100:50 PBW
  • Mixture consistency: Medium viscosity liquid
  • Filler loading possible
  • Optics: Transparent/Translucent
  • Old to new concrete bonding
  • Crack sealing
  • Primer
Surface Preparation
  • The mixture should be applied on a clean, rough and dry surface. This should be achieved by suitable mechanical and chemical means such as sandblasting Wire brushing or chemical etching. Suitable degreasing agent should be used to remove any grease, or oil traces on the surface.
Application Method
  • Use Jpoxy Part-A & Part-B in ratio 100:50 pbw. Mix the two components in small batches thoroughly for at least 2minutes. Apply the mix directly or by using brush/roller to the pretreated surfaces.
  • Allow the material to cure for at least 24 hours before putting to use.
Login to Download TDS
Q1. What makesMR. JO Bondkot-STD special?

A1. It offers faster curing than MR. JO Bondkot-MVC or LVC — ideal for jobs needing quicker turnaround.

Q2. Is MR. JO Bondkot-STD usable as a primer too?

A2. Yes — use a thin coat to prime before mortar placement.

Q3. Can it be used in colder climates?

A3. Yes — its faster reactivity helps in low temperatures.

Q4. Can I use MR. JO Bondkot-STD instead of MR. JO Bondkot-MVC for normal bonding?

A4. Yes — choose STD when time is critical.

Q5. Can I add silica to make patch mortar?

A5. Yes. Commonly used at 1:3 ratio.

Q6. What is the pot life of MR. JO Bondkot-STD?

A6. ~25–35 minutes at 25°C.

Q7. What is the overlay or recoating time? A7. ~2–3 hours — much faster than MR. JO Bondkot-MVC or LVC.

Q8. Does it self-level?

A8. Moderate flow — not ideal for deep cavities

Q9. Can I apply MR. JO Bondkot-STD to damp concrete?

A9. No. For that, use MR. JO Bondkot-UPS.

Q10. Is it paintable after cure?

A10. Yes — apply epoxy coatings after full cure.

Q11. How long to wait before traffic/load?

A11. At least 24 hours under ambient conditions.

Q12. Is MR. JO Bondkoy-STD UV-resistant?

A12. No. Use coatings if surface will be exposed.

Q13. Can it be recoated with itself?

A13. Yes — within 2–4 hours, or sand after 24.

Q14. What color is MR. JO Bondkot-STD?

A14. Usually amber to pale yellow.

Q15. Is it compatible with dry-shake floors?

A15. Yes — if used as a primer below underlays.