MR. JO Teckot-CLR – Clear Protection, Clean Finish
When your walls or concrete don’t need color—but still deserve the best protection.
🧩 The Problem
Waterproofing often means white or pigmented coatings—which may not always be desirable, especially:
- On exposed concrete, natural stone, or heritage walls
- Where topcoat painting is planned later
- Or where visual inspection of the substrate is still needed
In such cases, contractors need a transparent, breathable, easy-to-apply waterproofing system that does the job without hiding the surface.
💧 The MR. JO Teckot-CLR Advantage
MR. JO Teckot-CLR is a water-based, clear epoxy coating that works both as a standalone waterproofing layer and a curing aid for freshly laid concrete.
Whether you’re protecting newly cast slabs, basement walls, or detailed brick surfaces, this system creates an invisible shield that resists water, bonds tightly, and cures into a durable epoxy film.
🧑🔧 Ideal For:
- Waterproofing exposed RCC surfaces
- Clear film protection on walls, parapets, bricks, stone, or concrete
- Use as a curing compound substitute on new concrete
- Interior or exterior waterproofing when a colorless look is preferred
- Underlayment before tile or paint applications
✨ Key Features:
- Transparent, breathable film
- Epoxy-grade waterproofing in a water-based system
- Low odor, low VOC
- Can be applied to damp or new concrete
- Brush or roller friendly
- No water dilution required – ready to mix and apply
- Economical yet effective
🧱 Surface Preparation
- Surfaces free from grease, laitance, dust, and oil
- Concrete or masonry treated with:
- High-pressure water or wet grit blasting, or
- 15% HCl etching followed by thorough rinsing
- Damp surfaces are acceptable — drying not mandatory
Like other Teckot systems, MR. JO Teckot-CLR performs best when applied to:
🛠️ Mixing & Application
- Mix Ratio: 100:100 by weight (Resin:Hardener)
- Water Addition: Not required
- Application: Brush or roller
- Coats: 2 coats recommended
- Coverage:
- First coat: 4–6 m²/kg
- Second coat: 5–7 m²/kg
- Adjusts based on surface porosity
- Pot life: 45–60 minutes at 25°C
- Curing:
- Initial set: 12–24 hours
- Full cure: 7 days
🧪 Dual Use Case: Waterproofing + Curing
On freshly poured concrete, Teckot-CLR can be used as a curing compound:
- Prevents rapid moisture loss, ensuring better hydration
- Forms a protective epoxy film that later acts as a primer or underlayment
- Ideal for basements, slabs, and sunken portions that need extended curing
🟡 Teckot Product Range at a Glance:
| Feature | Teckot-PRO | Teckot-RTU | Teckot-CLR |
| Appearance (after curing) | Glossy white | Semi-gloss off-white | Transparent |
| Mix Ratio | 1:1:1 by volume (First coat) 1:1:0.5 by volume (Second coat) | 1:1:0 by volume | 1:1:0 by volume |
| Water Addition | Mandatory | Optional (5–10 pbw) | Not needed |
| Tinting | Yes | Yes | Not recommended |
| Usage | Decorative + barrier | Volume jobs + control | Clear coat + curing |
| Cost Tier | Premium | Cost-effective | Most economical |
Leave a Reply